First of all take a silicone paper. Sheet of paper coated paper to prevent ink transfer from complying with the paper. With brightness levels in layers of paper helps determine printing ends that can cause.
Color (ink)
The system recommended ink Nylon north. It achieves maximum dolmen and resistance wash with Nylon catalytic ink. Generally added catalyst 5%. You can also add up to 1% of additive Flow impenetrability improve.
Tights: Normal recommendation is to print color Nylon 34-62 mesh. The painting is best recommended to print Nylon Super Tex Parasol emulsion.
Wipe: Ink is dry for 24 hours or forced drying (Jet / IR 80 ° C). Ink must dry before applying the adhesive. Exposure imagery in temperatures above 80 ° C as totally retikulasyon. This leads to reticulum dolmen poor and low resistance between layers of wash. Opposite the maximum found in opposite will apply a layer of
White Nylon NX021.
One can add a 1% Hold Out additive further increase opposite. Using a specific metallic silver layer allows the creation of a block red ink. Nylon VVX44 Silver ink is a solvent-based two-component, when properly cured, creating a barrier between the adhesive and color. This sheet of red ink barriers reduces bleeding. 43-63 should use wire mesh for each centimeter.
Tape:
Recommended adhesives are Multiracial MAC cervix plastic. Incorporation in plastic technology allows for greater variety of production. Also available are white and transparent adhesives.
Transfer
It is made with a transfer sheet, usually in 175-190 ° C. Put clothes on the lower plate and roll the craft on clothes, with the written and printed off. Close the plate (typically at pressures of 60 psi) left for 10-15 seconds. When cold print, the paper is separated from clothing and carefully left his impression. You can buy athletes clothing right now.
Color (ink)
The system recommended ink Nylon north. It achieves maximum dolmen and resistance wash with Nylon catalytic ink. Generally added catalyst 5%. You can also add up to 1% of additive Flow impenetrability improve.
Tights: Normal recommendation is to print color Nylon 34-62 mesh. The painting is best recommended to print Nylon Super Tex Parasol emulsion.
Wipe: Ink is dry for 24 hours or forced drying (Jet / IR 80 ° C). Ink must dry before applying the adhesive. Exposure imagery in temperatures above 80 ° C as totally retikulasyon. This leads to reticulum dolmen poor and low resistance between layers of wash. Opposite the maximum found in opposite will apply a layer of
One can add a 1% Hold Out additive further increase opposite. Using a specific metallic silver layer allows the creation of a block red ink. Nylon VVX44 Silver ink is a solvent-based two-component, when properly cured, creating a barrier between the adhesive and color. This sheet of red ink barriers reduces bleeding. 43-63 should use wire mesh for each centimeter.
Tape:
Recommended adhesives are Multiracial MAC cervix plastic. Incorporation in plastic technology allows for greater variety of production. Also available are white and transparent adhesives.
|
|
|
It is made with a transfer sheet, usually in 175-190 ° C. Put clothes on the lower plate and roll the craft on clothes, with the written and printed off. Close the plate (typically at pressures of 60 psi) left for 10-15 seconds. When cold print, the paper is separated from clothing and carefully left his impression. You can buy athletes clothing right now.
No comments:
Post a Comment